Reassembly

INTERIOR PANELS / TRIM: ROOF SUNSHADE: REASSEMBLY

1. INSTALL NO. 2 SUNSHADE TRIM SUB-ASSEMBLY

HINT
Perform this procedure only when the No. 2 sunshade trim sub-assembly needs to be replaced.

(a) Remove the tape from a new No. 2 sunshade trim sub-assembly.

(b) Place a socket wrench on the hexagonal part shown in the illustration and turn the No. 2 sunshade trim assembly 15 times in the direction indicated by the arrow (1) shown in the illustration.





Text in Illustration





HINT
Torque: 0.23 N*m (2.35 kgf*cm, 2.04 in.*lbf)

(c) Insert a 2.5 mm hexagon wrench into the circular hole of the No. 2 sunshade trim assembly as shown in the illustration.

NOTICE:
Make sure that the hexagon wrench does not fall out when installing the No. 2 sunshade trim assembly.

(d) As shown in the illustration, insert the guide so that the hexagon wrench is upright.





Text in Illustration





(e) Press the pin in the direction indicated by the arrow (1) shown in the illustration.

(f) Slide the No. 2 sunshade trim sub-assembly in the direction indicated by the arrow (2) shown in the illustration to install it.

(g) Remove the 2.5 mm hexagon wrench.

HINT
Use the same procedure for the other side sunshade trim.

2. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

(a) Wrap the sunshade cover as shown in the illustration.





Text in Illustration





(b) Insert the ends of the sunshade cover to the slide roof rail sub-assembly.

(c) Using a T20 "TORX" socket wrench, install the sunshade trim sub-assembly to the slide roof rail sub-assembly with the 4 "TORX" screws.

Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)

(d) Install the 8 screws.

Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

3. INSTALL SLIDING ROOF DRIVE GEAR ASSEMBLY

(a) Install the sliding roof drive gear assembly with the 2 bolts.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

4. INSTALL CONNECTOR WIRE

(a) Connect the connector.





(b) Engage the 3 clamps to install the connector wire.

5. INSTALL NO. 2 SUNSHADE GARNISH LH

(a) Install the No. 2 sunshade garnish LH with the 2 screws.





Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

6. INSTALL NO. 2 SUNSHADE GARNISH RH

HINT
Use the same procedure as for the LH side.

7. INSTALL NO. 1 SUNSHADE GARNISH LH

(a) Install the No. 1 sunshade garnish LH with the 2 screws.





Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

8. INSTALL NO. 1 SUNSHADE GARNISH RH

HINT
Use the same procedure as for the LH side.