Installation
2GR-FE EMISSION CONTROL: HEATED OXYGEN SENSOR: INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR (for Sensor 2)
(a) Using SST, install the sensor to the exhaust pipe.
SST : 09224-00010
Torque : 40 Nm (408 kgf-cm, 30 ft-lbf) for use with SST
Torque : 44 Nm (449 kgf-cm, 32 ft-lbf) for use without SST
HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
* Make sure SST and a wrench are connected in a straight line.
(b) Connect the sensor connector.
(c) Bank 1 Sensor 2:
Install the rear console box Installation.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. CHECK FOR EXHAUST GAS LEAKS