Installation

2GR-FE EMISSION CONTROL: HEATED OXYGEN SENSOR: INSTALLATION

1. INSTALL HEATED OXYGEN SENSOR (for Sensor 2)





(a) Using SST, install the sensor to the exhaust pipe.

SST : 09224-00010

Torque : 40 Nm (408 kgf-cm, 30 ft-lbf) for use with SST

Torque : 44 Nm (449 kgf-cm, 32 ft-lbf) for use without SST

HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
* Make sure SST and a wrench are connected in a straight line.

(b) Connect the sensor connector.

(c) Bank 1 Sensor 2:

Install the rear console box Installation.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

3. CHECK FOR EXHAUST GAS LEAKS