Removal

POWER ASSIST SYSTEMS: POWER STEERING ECU: REMOVAL

1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
* After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
* Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE FRONT DOOR SCUFF PLATE LH Removal

4. REMOVE COWL SIDE TRIM BOARD LH Removal

5. REMOVE INSTRUMENT SIDE PANEL LH Removal

6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Removal

7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Removal

8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Removal

9. REMOVE POWER STEERING ECU ASSEMBLY





(a) Disconnect the power steering ECU connector.

(b) Remove the nut and power steering ECU assembly.