Installation
2GR-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
Text in Illustration
NOTICE:
* When reusing the sensor, inspect the O-ring.
* If the O-ring has scratches or cuts, replace the crankshaft position sensor.
(b) Install the crank position sensor with the bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the crank position sensor connector.
2. INSTALL W/PULLEY COMPRESSOR ASSEMBLY
Installation