Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.
1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Confirm that the front tires face straight forward.
(d) Confirm that the turn signal switch is in the neutral position.
NOTICE:
Perform the operation when the turn signal switch is in the neutral position. Otherwise, the turn signal pin will break.
(e) Engage the 3 claws and install the spiral with sensor cable sub-assembly.
NOTICE:
Pull the lock pin out before installing the steering wheel when replacing the spiral with sensor cable sub-assembly with a new one.
(f) Connect the airbag connector.
(g) Connect the horn connector.
(h) Connect the steering angle sensor connector.
CAUTION:
* Do not replace the spiral with sensor cable sub-assembly when the ignition switch is ON and the battery cable is connected.
* Do not rotate the spiral with sensor cable sub-assembly when the ignition switch is ON and the battery cable is connected.
* Make sure the steering wheel is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).
* Do not remove the steering angle sensor from the spiral cable.
* If there is a malfunction in the steering angle sensor, replace the spiral with sensor cable sub-assembly.
2. INSTALL UPPER STEERING COLUMN COVER Installation
3. INSTALL LOWER STEERING COLUMN COVER Installation
4. ADJUST SPIRAL CABLE Installation
5. INSTALL STEERING WHEEL ASSEMBLY Installation
6. INSPECT STEERING WHEEL CENTER POINT
7. INSTALL STEERING PAD Installation
8. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation
9. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation
10. POSITION FRONT WHEELS FACING STRAIGHT AHEAD
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
12. INSPECT STEERING PAD Installation
13. INSPECT SRS WARNING LIGHT
Diagnosis System