Installation

1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

(b) Install the crankshaft position sensor with the bolt.

Torque : 10 Nm (102 kgf-cm, 7.4 ft-lbf)

(c) Connect the crankshaft position sensor connector.

2. INSTALL COOLER COMPRESSOR ASSEMBLY

(a) Install the cooler compressor assembly with the 4 bolts.

Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)

(b) Connect the cooler compressor assembly connector.

(c) Install the suction hose sub-assembly with the bolt.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

3. INSTALL GENERATOR ASSEMBLY Installation

4. INSTALL FAN SHROUD Installation

5. INSTALL V-BANK COVER Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)