Installation

1GR-FE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

1. INSTALL E.F.I. ENGINE COOLANT TEMPERATURE SENSOR





(a) Using a 19 mm deep socket wrench, install the water temperature sensor with a new gasket.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(b) Connect the connector.

2. CONNECT FUEL PIPE SUB-ASSEMBLY NO.2 Installation

3. INSTALL INTAKE AIR SURGE TANK Installation

4. INSTALL AIR CLEANER ASSEMBLY

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

6. ADD ENGINE COOLANT Service and Repair

7. CHECK FOR FUEL LEAKAGE

8. CHECK FOR ENGINE COOLANT LEAKAGE Service and Repair

9. INSTALL V-BANK COVER Installation