Brake Warning Light does not Come ON

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster): Brake Warning Light does not Come ON
- Brake Warning Light does not Come ON

DESCRIPTION

Refer to Brake Warning Light Remains ON Brake Warning Light Remains ON.

WIRING DIAGRAM

Refer to Brake Warning Light Remains ON Brake Warning Light Remains ON.

INSPECTION PROCEDURE

NOTICE:
* When replacing the skid control ECU (master cylinder solenoid), perform calibration Vehicle Stability Control System (for Hydraulic Brake Booster).
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. INSPECT BRAKE WARNING LIGHT

(a) Disconnect the skid control ECU (master cylinder solenoid) connector.

(b) Turn the ignition switch to ON.

(c) Check that the BRAKE warning light comes on.

OK:

BRAKE warning light comes on.

NG -- CHECK CAN COMMUNICATION LINE

OK -- REPLACE MASTER CYLINDER SOLENOID Disassembly

2. CHECK CAN COMMUNICATION LINE Brake Warning Light Remains ON

NG -- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How to Proceed With Troubleshooting
OK -- Continue to next step.

3. PERFORM ACTIVE TEST USING TECHSTREAM (Indicate Lamp Brake) Brake Warning Light Remains ON

NG -- GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How To Proceed With Troubleshooting

OK -- REPLACE MASTER CYLINDER SOLENOID Disassembly