Slip Indicator Light Remains ON

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster): Slip Indicator Light Remains ON
- Slip Indicator Light Remains ON

DESCRIPTION

The slip indicator light blinks during VSC or TRAC and AUTO LSD operation. When the system fails, the slip indicator light comes on to warn the driver.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When replacing the skid control ECU (master cylinder solenoid), perform calibration Vehicle Stability Control System (for Hydraulic Brake Booster)
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK THAT SKID CONTROL ECU CONNECTOR SECURELY CONNECTED

(a) Check the skid control ECU (master cylinder solenoid) connector connection.

OK:

The connector is securely connected.

NG -- CONNECT CONNECTOR TO ECU CORRECTLY
OK -- Continue to next step.

2. CHECK DTC

(a) Check for DTCs Vehicle Stability Control System (for Hydraulic Brake Booster).

Result





B -- REPAIR CIRCUITS INDICATED BY OUTPUT DTCS Vehicle Stability Control System (for Hydraulic Brake Booster)
A -- Continue to next step.

3. INSPECT BATTERY

(a) Inspect the battery voltage Testing and Inspection.

Standard voltage:

11 to 14 V

NG -- CHECK CHARGING SYSTEM Testing and Inspection
OK -- Continue to next step.

4. CHECK CAN COMMUNICATION LINE

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus Diagnosis System.

OK:

CAN Bus Check indicates no malfunctions in CAN communication.

NG -- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How to Proceed With Troubleshooting
OK -- Continue to next step.

5. PERFORM ACTIVE TEST USING TECHSTREAM (Indicate Lamp Slip)

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(f) According to the display on the Techstream, perform the Active Test.

Combination Meter





(g) Check that the Slip indicator light on the combination meter assembly turns on or off in accordance with the Techstream operation.

OK:

The Slip indicator light turns on or off in accordance with the Techstream operation.

NG -- GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How To Proceed With Troubleshooting
OK -- Continue to next step.

6. CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)

(a) Disconnect the skid control ECU (master cylinder solenoid) connector.

(b) Measure the voltage according to the value(s) in the table below.





Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

7. CHECK HARNESS AND CONNECTOR (GND TERMINAL)

(a) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





Text in Illustration





(b) Reconnect the skid control ECU (master cylinder solenoid) connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE MASTER CYLINDER SOLENOID Disassembly