Driver Side Seat Belt Warning Light Does Not Operate

METER: METER / GAUGE SYSTEM: Driver Side Seat Belt Warning Light does not Operate
- Driver Side Seat Belt Warning Light does not Operate

DESCRIPTION

When the ignition switch is ON, the combination meter assembly receives signals from the front seat inner belt assembly (driver side). When the seat belt is unfastened, the combination meter assembly flashes the driver seat belt warning light in the combination meter assembly. When the seat belt is fastened, the combination meter assembly stops flashing the front driver seat belt warning light.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER SIDE SEAT BELT)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(e) According to the display on the Techstream, perform the Active Test.

Combination Meter





OK:

Driver side seat belt warning light condition can be switched by Active Test.

NG -- REPLACE COMBINATION METER ASSEMBLY Removal
OK -- Continue to next step.

2. CONFIRM SEAT TYPE

(a) Confirm the seat type.

Result





B -- INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)
A -- Continue to next step.

3. INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)

(a) Disconnect the F22 front seat inner belt assembly (driver side) connector.

(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





Text in Illustration





(c) Reconnect the front seat inner belt assembly (driver side) connector.

NG -- REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) Removal
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) - COMBINATION METER ASSEMBLY AND BODY GROUND)

(a) Disconnect the F22 front seat inner belt assembly (driver side) connector.

(b) Disconnect the C9 combination meter assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(d) Reconnect the combination meter assembly connector.

(e) Reconnect the front seat inner belt assembly (driver side) connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE COMBINATION METER ASSEMBLY Removal

5. INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)

(a) Disconnect the F21 front seat inner belt assembly (driver side) connector.

(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





Text in Illustration





(c) Reconnect the front seat inner belt assembly (driver side) connector.

NG -- REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) Removal
OK -- Continue to next step.

6. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) - COMBINATION METER ASSEMBLY AND BODY GROUND)

(a) Disconnect the F21 front seat inner belt assembly (driver side) connector.

(b) Disconnect the C9 combination meter assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(d) Reconnect the combination meter assembly connector.

(e) Reconnect the front seat inner belt assembly (driver side) connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE COMBINATION METER ASSEMBLY Removal