Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2012 >> Tundra 2WD V6-4.0L (1GR-FE) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Information Bus >> Testing and Inspection >> Symptom Related Diagnostic Procedures >> LIN Communication System >> Integration Control and Panel Assembly Communication Error (from 08/2011)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Integration Control and Panel Assembly Communication Error (from 08/2011)





MULTIPLEX COMMUNICATION: LIN COMMUNICATION SYSTEM: Integration Control and Panel Assembly Communication Error
- Integration Control and Panel Assembly Communication Error

DESCRIPTION

The LIN communication of the components related to the mirror heater occurs between the air conditioning amplifier assembly (A/C ECU) and integration control and panel assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
When using the Techstream with the ignition switch OFF to troubleshoot:

Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - INTEGRATION CONTROL AND PANEL)





(a) Disconnect the J37 integration control and panel assembly connector.

(b) Disconnect the J19 air conditioning amplifier assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - BATTERY AND BODY GROUND)

(a) Disconnect the J37 integration control and panel assembly connector.





(b) Measure the resistance and voltage according to the value(s) in the table below.

Standard Resistance:





Standard Voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. CHECK INTEGRATION CONTROL AND PANEL ASSEMBLY (OPERATION)

(a) Temporarily replace the integration control and panel assembly with a new or normally functioning one.

(1) For Column Shift Type, refer to the following procedures Removal (from 08/2011).

(2) For Floor Shift Type, refer to the following procedures Removal (from 08/2011).

(b) Check that the malfunction disappears.

OK:

Malfunction disappears.

NG -- REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Removal (from 08/2011)

OK -- END (INTEGRATION CONTROL AND PANEL ASSEMBLY IS DEFECTIVE)
pro multis · About Operation CHARM