Installation

A760E AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the switch to the manual valve shaft.

(b) Temporarily install the bolt.

(d) Temporarily install the control shaft lever RH.

(e) Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.

(f) Align the groove with the neutral basic line.

(g) Hold the switch in position and tighten the bolt.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(h) Using a screwdriver, bend the tabs of the lock washer.

(i) Install the transmission control shaft lever RH with the spring washer and nut.

Torque : 16 Nm (160 kgf-cm, 12 ft-lbf)

(j) Connect the switch connector.

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Connect the cable with the nut.

Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

NOTICE:
When connecting the cable to the transmission control shaft lever, make sure the L bracket of the cable faces the inside of the vehicle.

3. ADJUST SHIFT LEVER POSITION (for Column Shift Type) Shift Lever Assembly (for Column Shift Type)

4. ADJUST SHIFT LEVER POSITION (for Floor Shift Type) Shift Lever Assembly (for Floor Shift Type)

5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Inspect the switch Initial Inspection and Diagnostic Overview.