Installation

1NZ-FE ENGINE CONTROL: ECM (for Sedan): INSTALLATION

1. INSTALL ECM BRACKET NO. 2





(a) Install ECM bracket No. 2 with the 2 screws.

2. INSTALL ECM BRACKET





(a) Install the ECM bracket with the 2 screws.

3. INSTALL ECM





(a) Install the ECM with the bolt and 2 nuts.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Connect the 2 ECM connectors.

(c) Install the 2 lock knobs and harness clamp.





4. INSTALL COWL TOP PANEL OUTER

(a) Install the cowl top panel outer and install the 8 bolts.





Torque : 6.5 Nm (66 kgf-cm, 58 in-lbf)

(b) Install the cowl top panel outer center bracket and install the 2 bolts.





Torque : 6.5 Nm (66 kgf-cm, 58 in-lbf)

(c) Connect the wire harness and engage the claw.





5. INSTALL FRONT AIR SHUTTER SEAL

(a) Install the front air shutter seal and engage the 3 claws.





6. INSTALL FRONT WIPER MOTOR AND LINK Installation

7. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

8. INSTALL COWL SIDE VENTILATOR SUB-ASSEMBLY LH Installation

9. INSTALL COWL SIDE VENTILATOR SUB-ASSEMBLY RH Installation

10. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

11. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

12. INSTALL FRONT WIPER ARM HEAD CAP Installation

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)