Differential Assembly

Installing Differential Bearing Inner Race (Ring Gear Side)





- Heat to approx. 100°C (212°F) and press on

Installing Differential Bearing Inner Race (Housing Side)





- Heat to approx. 100°C (212°F) and press on

Installing Ring Gear





CAUTION: Clean contact surfaces are essential to ensure that ring gear, differential housing, and cover fit properly. Remove all burrs and pressure marks with oil stone.

- Heat ring gear to approx. 100°C (212°F) and install
^ A = centering pins (local manufacture)

NOTE: If ring gear/pinion are replaced, readjustment is necessary.

Installing Differential Bearing Outer Race





- Press race in until seated
- To complete assembly, Differential Adjustments