Window Drive Cable/Motor - Replacement Instructions
90vw04Subject: Window regulator drive cable/motor, replacing
Quantum 1982-1988 m.y.
Model(s): Golf/Jetta 1985-1990 m.y.
Group: 64
Number: 90-02
Date: June 30, 1990
Window regulator drive cable, motor, replacing
Note
Before replacing window regulator motor, check window switch, electrical wiring and mechanical portion of regulator assembly for proper operation.
CAUTION
Disassemble window regulator assembly on clean work surface.
NO dirt or dust must enter motor.
Relubricate with grease G 000 450 02 or equivalent as required.
CAUTION
Part numbers are for reference only. Always check with your Parts Department for latest parts information.
Parts required
Golf/Jetta
Quantum
^ remove door trim panel
^ pull back plastic moisture barrier
^ pull off terminal connector for regulator motor
^ remove regulator mounting bolts, and remove regulator from inner door panel
^ with regulator removed from door assembly clamp housing cover and plastic bearing cover together with tie-wraps as shown (arrows)
CAUTION
Do not remove tie-wraps after completing repair.
^ remove mounting bolts securing motor to drive cable housing (arrows)
^ using a rocking motion, carefully separate drive cable and cable spool from motor
^ do not damage mating surface
^ reinstall replacement window regulator drive cable or motor
^ apply slight amount of grease to secure gasket a when installing
^ check window regulator drive cable or motor for proper function
^ reinstall all other components in reverse order of removal