Vehicles Built Until: 8-91

1- Solenoid valve I (N 80)
- gray
- when the ignition is switched off the valve is open in the direction of the arrow
- when the engine is warm the valve is activated (pulsed) by the Engine Control Module
- checking, - Repair Group 01 - Output Diagnostic Test Mode
2- Retaining ring
3- Solenoid valve II (N 115)
- black
- must open when the ignition is switched on
4- Throttle body
5- Harness connector
- grey
6- Harness connector
- black
7- Mounting bracket
- on Mass Air Flow sensor
8- Carbon canister
- located in right, front wheel housing
9- Vent line
- from gravity valve on fuel tank, see item 1 in "Fuel Tank, Replacing, Disassembling and Assembling". Service and Repair
10- 10 Nm (7ft lb)