Throttle Position Sensor: Service and Repair

REPLACING THROTTLE POSITION SENSOR




- Remove two screws -3-.
- Remove Throttle Position (TP) Sensor -4-.

^ Throttle valve -2- in Closed Throttle Position.
^ New O-ring -1-.

- Install Throttle Position Sensor in reverse order of removal.
- Tightening torque (screws -3-) to 3 Nm (27 in lb).
- After installing the Throttle Position Sensor, the Motronic Engine Control Module (ECM) must be returned to basic settings.

NOTE: On vehicles with automatic transmission, the Transmission Control Module must also be returned to basic settings.