Glass Panel For Sunroof, Adjusting (Height Adjustment)

Glass Panel For Sunroof, Adjusting (Height Adjustment)

- "0" position of sunroof OK.

- Tilt glass panel open.
- Slide back sun protection completely.
- Unclip lower trim - 1 - in front area to vehicle center. Slide forward out of elongated hole and remove.
- Unclip top cover - 2 - at front and in center (pins - 3 -) and remove in direction of - arrow -.
- Move glass panel to "0" position.







Perform height adjustment of glass panel at front and rear according to illustrations to prevent wind noise.

Panel adjustment at front:
- a - = 01 mm lower than roof







- arrow - = direction of travel

Panel adjustment at rear:
- b - = 01 mm higher than roof
- arrow - = direction of travel

- Tighten glass panel bolts (4.5 Nm).







Always adjust left and right-hand glass panel sides symmetrically.

- Insert panel at top - 2 - in direction of - arrow -, clip in with pins - 3-.







- Slide lower trim - 1 - in direction of - arrow - into rear oversized hole and clip in at front area.

NOTE: Height adjustment of glass panel must be checked from out of sliding position.