Input Shaft, Pinion Shaft, Shift Rods and Transmission

Input shaft, pinion shaft, shift rods and transmission, disassembly and assembly





1. Selector shaft with shift fork for 3rd and 4th gear
^ Disassembling and assembling Shifter M/T
^ Replacing mounting bushings
2. Input shaft
^ Disassembling and assembling Input Shaft
^ Adjusting
^ Servicing input shaft bearings
3. Left stop screw
^ 40 Nm (30 ft. lbs.)
4. Washer
5. Relay shaft
^ Installation position
6. Washer
7. Right stop screw
^ 40 Nm (30 ft. lbs.)
8. Shift rod
^ Installation position Shifter M/T
^ Replacing shift rod oil seal Shifter M/T
9. Shift detent
^ Installation position
10. Torx(R) screw
^ 25 Nm (18 ft. lbs.)
^ With shoulder to secure the shift detent spring
11. Shift rod with 1st/2nd/5th and reverse rear shift forks
^ Disassembling and assembling
^ Replacing mounting bushings
12. Pinion shaft
^ Disassembling and assembling Differential
^ Adjusting
^ Servicing pinion shaft bearings
13. Transmission cover
^ Removing and installing oil collector tray; see Fig. 1
14. Transmission housing
15. Torx(R) screw





Fig. 1 Removing and installing oil collector tray

Removing
- Turn oil collector tray and then pull out

Installing
Installation position:
The oil collector tray faces upward in the transmission cover.
- Push oil collector tray into transmission until it snags in.