Power Locks

Central locking, removing and installing







1 - Front door lock positioning element

2 - T-fitting
- Location: B-pillar/sill, covered by sill trim

3 - Fuel filler flap position
- To remove trunk trim must be disconnected first, up to wheel house

4 - Bi-pressure pump

5 - Rear lid position

6 - Front door positioning element

7 - Multi-pin connector
- Location: A-pillar

8 - Colored mark
- Bi-pressure lines must be pushed into connector up to colored mark

9 - Bi-pressure line connector
- Two build levels are possible: connector located in or outside multi-pin connector
- If connector is located outside, after assembly, bi-pressure
line connector must be pushed into multi-pin connector
- If connector is located in multi-pin connector, then multi- pin connector must be disconnected to disconnect bi-pressure line