Diagnostic Mode 1: Check Measured Values

Diagnostic Mode 1: Check Measured Values

Requirement
- Coolant temperature must be at least 80 degree C see PID 5, Coolant temperature.

Work procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Depending on the desired operating condition:switch on ignition
or start engine and let run at idle.
- Under address word 33, select "Diagnostic mode 1: Check measured values."
- Select the desired measured value(s) "PID XX".

NOTE:
- The specified values for the respective measuring values can be found at the respective component- and function tests.
- The following list only serves as an overview.
- The measured values are sorted according to the PID (parameter-identifications).

PID Display measuring values
01: Monitoring status since erasing DTC memory
04: Calculated load condition value
05: Coolant temperature
11: Intake manifold pressure
12: Engine rotations per minute (RPM)
13: Vehicle speed
14: Valve timing adjustment at 1. cyl. to "advance"
15: Intake Air Temperature (IAT)
16: Air flow quantity at Mass Air Flow (MAF) sensor
17: Throttle valve position (absolute)
28: OBD requirement for which this vehicle is designed
33: Distance driven with MIL on (km)

- End diagnosis and switch ignition off.