Sunroof With Glass Panel, Assembly Overview

Sunroof With Glass Panel, Assembly Overview







1 - Glass panel for sunroof (single pane safety glass)
- Removing glass panel for sunroof
- Installing glass panel for sunroof
- Adjusting glass panel for sunroof

2 - Panel seal
- Panel seal, replacing

3 - Sliding headliner
- Removing and installing Sliding headliner

4 - Slider
5 - Lower trim
- Vehicles up to calender week 35 2002 (CW 35/02)

6 - Upper trim
- Vehicles up to calender week 35 2002 (CW 35/02)

7 - Water channel
- Removed together with slotted guide rail

8 - End piece
- Use Butyl adhesive sealing cord AKL 450 005 05 for sealing

9 - Bolt
- 3.5 Nm

10 - Installation unit
- Removing installation unit
- U-frame (with guide channels), if necessary use special grease G 000 450 02 exclusively to grease guide channels, otherwise functions cannot be guaranteed.

11 - Drive motor
- Adjusting drive motor (zero position)

12 - Bolt
- 3.5 Nm

13 - Hex wrench for emergency operation
- Clipped in on drive motor cover

14 - Cover
15 - Spring
16 - Wind deflector
17 - Wind deflector mounting
18 - Torx screw
- Torx T25
- 4.5 Nm

19 - Slotted guide rail
20 - Guide with cable
21 - Carriage for water channel
22 - Countersunk screws (microencapsulated)
- Always use new countersunk screws
- 3.5 Nm

23 - Trim pieces
- Vehicles from calender week 36 2002 (CW 36/02) on

NOTE: Trim pieces and trim must not be swapped with each other during replacement. Clearance for mechanical components is otherwise not guaranteed.