Control Module For High Intensity Gas Discharge (HID) Lamp

Control Module For High Intensity Gas Discharge (HID) Lamp, Removing And Installing

Removing


WARNING!
- HIGH VOLTAGE!
- Always disconnect battery Ground (GND) strap prior to servicing any parts of the HID lamp system marked with the yellow "HIGH VOLTAGE!" symbol.
- After disconnecting battery, briefly turn headlights on and off in order discharge any residual voltage.


- Remove headlight assembly.







- Disconnect electrical connector -5-.
- Remove mounting screw -4-.
- Unclip retainer -7- and pull out control module -6-.
- Remove three screws -arrow- and remove large cover cap -1-.







- Turn connector coupling -1- counterclockwise 90° and pull off.
- Pull electrical harness from control module to HID lamp out from headlight housing.

Installing
Installation is in reverse order of removal.
- Check function of headlight (HID lamp).
- Check headlight aim.

Aiming must be done in conjunction with the On Board Diagnostic (OBD) program "Basic Setting" (Scan Tool function 04).