With Manufacturer Scan Tool

Erase DTC Memory


NOTE: All functions which could previously be performed with VAG 1551 can also be performed with the new tester VAS 5051.

Requirement:
- DTC memory checked.

After DTC memory has been checked:

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press keys 0 and 5. (The function "Erase DTC memory" is entered with 05.)

Indicated on display:


Rapid data transfer Q
05 Erase DTC memory

- Confirm entry with key Q.

Indicated on display:


WARNING!
DTC memory was not checked


The work sequence was not adhered to exactly. The DTC memory must first be checked.

NOTE: If the ignition was switched off e.g. between checking the DTC memory and erasing DTC memory, the DTC memory is then not erased.

Indicated on display:


Rapid data transfer ->
DTC memory is erased!


(The DTC memory will be erased approx. 5 seconds, after the display appears.)

The DTC memory is now erased.
- Wait about 1 minute before again checking the DTC memory.

Indicated on display:


System cannot be checked!


- Print out with printer switched on:


1 Fault recognized !
00811 3333
System cannot be checked


Control module -J217- was not given sufficient time to recognize faults.
- Wait about 1 minute before again checking the DTC memory.
- After checking and erasing the DTC memory, carry out a test drive and again check the DTC memory.

When the DTC memory is checked, the following display should appear:
No DTC recognized!


"No DTC recognized!"