Load Compensator: Service and Repair

Component Notes And Information

NOTE:
^ During service procedures, refer to the illustration above and the information below.
^ Vehicles with all-wheel drive, ABS Bosch 5.3 and some other models are not equipped with a brake pressure regulator.

1 Brake pressure regulator
- Adjusting. Adjustments
2 Securing clip
- Press onto threaded stud and tighten with 2 to 3 turns
3 Hex bolt
- Tighten to: 20 Nm (15 ft lb)
4 Hex bolt
- Tighten to: 20 Nm (15 ft lb)
5 Nut
6 Spring mounting
- Mark installation position before removing
7 Spring
- Note installation position
- Observe application, refer to Steering and Suspension
8 Clip
9 Horizontal beam
- Slight inclination is permissible. Adjustments
10 Buffer stop
- Adjusting. Adjustments
11 Control arm