Threads In Longitudinal Member, Servicing

Threads in longitudinal member, servicing

It is possible to service the threads in the nuts welded in the longitudinal member depending on certain conditions.

^ Servicing work may only be carried out once per thread.
^ If servicing is necessary, the nuts must be replaced.
^ Observe the operating instructions of the VAS repair kit.

WARNING:
When drilling, it is essential to use eye protection!

^ Have your work checked by the foreman responsible or person next in charge.
^ Any damage caused to the underbody sealant layer should be repaired; Notes covering this can be found in booklet:
^ Only use the VAS repair kit listed in the table for servicing work





VAS thread repair kit