Parallel Movement, Adjusting
Parallel Movement, Adjusting
NOTE: Parallel movement adjustment can only be performed with drive motor removed and glass panel (in zero position).
- Removing drive motor for sunroof.
Vehicles up to calender week 31 1998 (CW 31/98)
Square holes in tilt levers must align with cut-outs in guide rails - arrow -.
- Install drive motor in "zero position"(markings in viewing window must align).
- Then check zero position.
Vehicles from calender week 32 1998 (CW 32/98) on
Guide rail pin must align with marking (pin) on guide rail - arrow -.