Ignition System Components, Removing and Installing
General Notes on Ignition SystemIgnition System Components, Removing and Installing
1 - High Tension cable
- 4 to 8 kOhms
- With suppression connector and spark plug connector
- Only remove and install spark plug connector using tool T10029
2 - Ignition coil with output stage (-N70-, -N127-, -N291-, -N292-)
Connection, ignition wires:
- HV1 = Cylinder 1
- HV2 = Cylinder 2
- HV3 = Cylinder 3
- HV4 = Cylinder 4
3 - 10 Nm
4 - Connector
- 6 pin
5 - Knock sensor 1 -G61-*
- Contacts gold plated
- Fitting location: Cylinder block intake side
6 - 2-pin connector
- For knock sensor 1 -G61-
- Contacts gold plated
- Do not interchange
7 - Knock sensor 2 -G66-*
- Contacts gold plated
- Fitting location: Cylinder block intake side
8 - 2-pin connector
- For knock sensor 2 -G66-
- Contacts gold plated
- Do not interchange
9 - 20 Nm
- Tightening torque influences the function of the knock sensor
10 - Spark plug, 30 Nm
- Type and electrode gap See test data, spark plugs.
- Remove and install with 3122B
11 - Connector
- Contacts gold plated
- 3 pin
12 - 10 Nm
13 - 100 Nm
- Use counter- hold tool 3415 to loosen and tighten
14 - Camshaft sprocket
- With rotor for Camshaft Position (CMP) sensor
15 - Camshaft Position (CMP) sensor -G40-*
16 - Bracket
- For Camshaft Position (CMP) sensor