Electrical Check of Mark 60

Electrical check of Mark 60

Special tools and equipment





- VAG 1598/36 Adapter
- VAG 1594 A Adapter set
- VAG 1526 A Hand multimeter
- VAG 1921 Pliers
- VAG 1598 A Test box

The test steps from Multi-Pin Connector With Contact Assignments apply only to vehicles with ABS/EDL/ASR/ESP
- For vehicles on which the On Board Diagnostic (OBD) does not give any indication of the source of the malfunction. Work through the complete electrical check.
- For vehicles on which the OBD provides a direct indication of the source of the malfunction. Only carry out the test steps recommended in the DTC table (directed entry).
An overview of all the test steps in the electrical check.

Test prerequisites
- Switch ignition and electrical consumers off before commencing the check (headlights, lighting, fans..).
- Fuses must be OK (remove fuses from fuse holder to check).
- Pull fuse holder out of cable channel.





- Release ABS Control Module (w/EDL) -J104- connector -arrow 1- and pull off-arrow 2-.





- Connect test box VAG 1598/36 -1- to multi-pin connector of ABS control module (w/EDL) -J104-2-.
The specified values are matched to the VAG 1526 and are not necessarily applicable for other test modules.