Transmission Position Sensor/Switch: Adjustments

5 Speed Automatic 09A

Multi-function transmission range (TR) switch -F125-, removing, installing and adjusting
Special tools and equipment





- T10091 Adjusting device





- V.A.G 1331 Torque wrench or equivalent

Removing multi-function TR switch
- Check whether a coded radio is installed. If so, obtain anti-theft coding.
- Switch ignition off and disconnect battery Ground strap.
- Install battery.
- Remove battery carrier.
- Shift selector lever into "P" position.





- Remove nut -arrow-.
- Pull lever -1- off selector shaft.
- Pull off multi-function switch connector
- Remove multi-function TR switch (F125)

Installing and adjusting multi-function TR switch





- Install multi-function TR switch -F125- on selector shaft.
Installation position: The groove -1- in the selector shaft must align with the multi-function TR switch -F125- marking -2-.





- Screw in multi-function TR switch -F125securing bolts (arrows) hand tight.
- Place adjusting device on selector shaft and secure.
- Shift lever/selector shaft on transmission to position "N".
- Turn switch until hole on switch housing -1- aligns with hole of adjusting device.





- Insert pin -2- from adjusting device.
- Tighten multi-function TR switch -F125- securing bolts (arrows) to 6 Nm.
Further installation in reverse order
- Check selector lever cable adjustment, Refer to Transmission and Drivetrain.
- Enter radio code.