Clutch Pedal & Over-Center Spring, Removing & Installing

Clutch Pedal & Over-Center Spring, removing & Installing
Overcenter spring, removing and installing
Special tools and equipment





^ T10111 Assembly device

Removing
^ Remove cover/lower drivers side.





^ Insert assembly device T10111 in overcenter spring from right side.
^ Make sure that assembly device seats correctly on overcenter spring:
1 - Assembly device must fit exactly onto overcenter spring rear part, with claws over bridge -1-.
2 - Lightly press clutch pedal in direction of bulkhead.
Hang assembly device tab -2- in overcenter spring cut out.
^ Press clutch pedal to bulkhead until overcenter spring can be taken out of support mountings and clutch pedal.
^ Make clutch pedal recede even more until it is in rest position.





^ Turn overcenter spring together with assembly device T10111 in direction of arrow -A- and take out downward in direction of arrow -B-.

Installing
^ Pull clutch pedal toward inside of vehicle.





^ Install overcenter spring together with assembly device T101 11 in direction of arrow -A- into support. When doing this turn in direction of arrow -B-.





^ Install overcenter spring on support in rear -arrow A-.
^ Press clutch pedal to bulkhead until overcenter spring lies against clutch pedal bearing tab -arrow B-.
^ Make pedal recede even more, until it is in rest position, and remove assembly device.
^ Install cover/lower drivers side.