Transverse Acceleration Sensor G200 and Rotation Rate Sensor G202, Removing and Installing

Transverse Acceleration Sensor G200 and Rotation Rate Sensor G202, removing and installing

On vehicles with a combined Transverse Acceleration Sensor G200 and Rotation Rate Sensor G202, the control module can be coded.
The Transverse Acceleration Sensor G200 and the Rotation Rate Sensor G202 are combined in a single housing. It is located beneath the rear seat bench.

Removing
- Remove rear seat bench.
- Disconnect connector from sensor for transverse acceleration/sender for rotation rate.





- Remove two securing nuts - arrows -.
- Remove sensor for transverse acceleration/sender for rotation rate.

Installing

CAUTION! Strong vibrations can destroy the sensor for transverse acceleration/sender for rotation rate.

- Installation is in reverse order of removal.

When installing sensor for transverse acceleration/sender for rotation rate, make sure it is correctly seated in its mounting and is stress free.

Do not use the securing nuts to forcibly position the sensor for transverse acceleration/sender for rotation rate.
- Tighten securing nuts to 6 Nm.