Steering Column: Diagrams

Steering Column Switches, Multi-pin Connector Assignments

-E22- Windshield Wiper/Washer Switch, -E38- Windshield Wiper Intermittent Regulator, -E86- Multi-Function Indicator Mode Select Switch, -E109- Multi-Function Indicator Memory Switch







A - Connector, 6-pin, -T6e- (MFI where applicable)
1. -E86- MFI call-up button -> right
2. -E86- MFI call-up button -> left
3. -E86- / -E109- -> terminal 31 (Ground)
4. -E109-MFI -> Reset
5. -E38- Interm. wiper regulator -> terminal 31 (ground)
6. -E38- Interm. wiper regulator -> -J31- Interm. relay

B - Connector, 8 pin, -T8b-
1. -E22- Wiper switch terminal 53 -> -V- windshield wiper motor
2. -E22- Wiper switch -> terminal 31 (ground, wagon only)
3. -E22- Windshield wiper terminal 53e -> -J31- Interm. relay(where applicable)
4. -E22- Wiper switch terminal 53e -> -J31- Interm. relay
5. -E22- Wiper switch terminal H -> -V59- / -V12- washer pump
6. -E22- Wiper switch terminal 53b -> -J31- Interm relay
7. -E22- Wiper switch terminal J -> -J31- Interm. relay
8. -E22- Wiper switch terminal 53a -> -S224- (terminal 75x)

-E2- Turn Signal Switch, -E4- Headlight Dimmer/Flasher Switch,

HL = Headlight
TS = Turn Signal







C - Connector, 12 pin, -T12-
1. -E4- HL dimmer/flasher -> terminal 30
2. -E4- HL dimmer/flasher -> terminal 30 (through 10.03 only)
3. -E2- TS switch -> terminal L
4. Open
5. -E2- TS switch -> terminal 49a
6. Open
7. -E4- HL dimmer/flasher -> terminal 56
8. -E4- HL dimmer/flasher -> terminal 56b
9. Open
10. Open
11. -E2- TS switch -> terminal R
12. -E4- HL dimmer/flasher -> terminal 56a

-E45- Cruise Control Switch, -E227- Button for Cruise Control (set)

NOTE:
- Cruise control switches on vehicles without Electronic Power Control (EPC) are connected to -J213- Cruise Control Module and the brake/clutch vent switches where applicable.
- Cruise control switches on vehicles with Electronic Power Control (EPC) are connected to -J220- Motronic Engine Control Module and -J248- Diesel Direct Fuel Injection (DFI) Engine Control Module (ECM) where applicable
- During troubleshooting, always use applicable Cruise Control System (CCS) or Engine system wiring diagrams.







D - Connector, 10 pin, -T10-
1. Open
2. -E45- switch -On/Off
3. -E227- switch - Set / accelerate
4. -E45- switch - Reset / Resume saved speed
5. -E45- switch - Reset / Resume saved speed
6. -E45- switch terminal 15a - On / Off
7. -E45- switch ->
8 - 10. Open