From 10/2000

Trunk Lid, Adjusting 10.00 -->

NOTE:
- Vehicle must stand on its wheels in order to be able to perform adjustment.
- Trunk lid is properly adjusted when re is an overall even gap dimension when closed, it is not too far inward or outward and contours align.
- Gap dimensions: Body panel gaps; Body, rear

- Loosen clamping screw (hex socket head 3 mm) enough until notched slider can be pulled out.







- Remove notched slider from housing and adjust to dimension - a - = 12.5 mm.

NOTE: In new condition, stopper is already adjusted to a distance of 12.5 mm.

- Close trunk lid using light pressure over center, pull handle while doing so.
- Open trunk lid again.
- Trunk lid is now Place to a pre-load of approx. 2 mm.
- Install clamp screw - 1 - until dimension - a - = 25 mm.







- Check setting.