Entry Lamps
Front Door Lamps and Switches
Entry Lamps
CAUTION!
When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool (plastic wedge, screwdriver) will be positioned using commercially available adhesive tape.
• Removal and installation for all entry lamps is performed in the same way and is only described for one lamp.
Entry lamps
• Left Front Entry Lamp (W31)
• Right Front Entry Lamp (W32)
• Left Rear Entry Lamp (W33)
• Right Rear Entry Lamp (W34)
Removing
- Switch off ignition, switch off all electrical consumers and remove ignition key.
- Carefully pry out lamp using a screwdriver.
- Release the connector and disconnect it.
Bulb, replacing
- Disengage retaining tabs - 1 - and remove heat shield - 2 - from diffusion lens of light.
- Carefully pry bulb from socket.
- Replace bulb (12V, 5 W).
Installing
Install in reverse order of removal.