Front Turn Signal Bulb

Halogen Headlamp Bulbs, through 11.06


Front Turn Signal Bulb

• Left Front Turn Signal Lamp (M5) and Right Front Turn Signal Lamp (M7) can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519) --> [ Vehicle Electrical System Output Diagnostic Test Mode ] Initial Inspection and Diagnostic Overview.

• Illustrations depict replacement of Front Turn Signal Lamp at left headlamp.

• Replacement of Left Front Turn Signal Lamp (M5) and Right Front Turn Signal Lamp (M7) is performed analogously.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove headlamp --> [ Headlamps, through 11.06 ] .

- Remove cover cap - arrow - at headlamp housing.





- Disconnect connector - arrows - at holder of Front Turn Signal Lamp.





- Turn socket of Front Turn Signal Lamp in - direction of arrow -.





- Remove socket with Front Turn Signal Lamp from reflector.

- Press Front Turn Signal Lamp into socket and turn Front Turn Signal Lamp toward left.

- Remove Front Turn Signal Lamp from socket.

Installing

Install in reverse order of removal, noting the following:

• When installing cap, ensure proper seating. It is destroyed by ingress of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the lamp is switched on, will evaporate and cloud the glass.

- Check headlamp for function.

- Check and adjust headlamp aim if necessary.