High Beam Bulb

Halogen Headlamp Bulbs, through 11.06


High Beam Bulb

• Left High Beam Headlamp (M30) and Right High Beam Headlamp (M32) can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519) --> [ Vehicle Electrical System Output Diagnostic Test Mode ] Initial Inspection and Diagnostic Overview.

• Illustrations depict replacement of High Beam Headlamp Lamp at left headlamp.

• Replacement of Left High Beam Headlamp (M30) and Right High Beam Headlamp (M32) is performed analogously.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove headlamp --> [ Headlamps, through 11.06 ] .

- Remove cover cap - arrow - at headlamp housing.





- Disconnect connector - 1 - and by doing so press retaining tab in - direction of arrow -.





- Turn lamp socket in - direction of arrow - and remove it from headlamp.





• The lamp for fog lamp is joined permanently to lamp socket and cannot be replaced separately.

Installing

Install in reverse order of removal, noting the following:

• When installing cap, ensure proper seating. It is destroyed by ingress of water into headlamp.

• Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the lamp is switched on, will evaporate and cloud the glass.

- Check headlamp for function.

- Check and adjust headlamp aim if necessary.