Differential Motor V253, Removing

Differential motor V253, removing

If Differential Motor V253 is replaced, observe the following:
The new Differential Motor is set to a specified position.
- To make installation easier, set this position on differential as well, if possible:





- To do this, switch ignition on.
- Rotate Transfer Case Operating Unit E473 to "LOW" position - arrow -.
- Then switch ignition off.

If previous Differential Motor will be reinstalled, Transfer Case Operating Unit E473 does not need to be set to the "LOW" position.

Continued for all
- If shield is installed over differential motor, remove it.





- Separate connectors - A -, - B - and - C -.
- Remove bracket - D - - arrows -.





- Remove bolts - arrows - and remove differential motor from transfer case.