Operation CHARM: Car repair manuals for everyone.

Assembly Unit






Assembly Unit

CAUTION!
Only remove and install drive motor for sunroof glass panel when roof is closed (zero position).

Requirements for removing and installing the drive motor are: Engine and ignition off, remove key and open door.

Removing





- Remove molded headliner

- Disconnect water drain hoses - 4 - from installation unit - 1 -.

- Disconnect harness connector - 3 - from drive motor of glass panel for sunroof - 5 -.

- Remove bolts - 2 - and remove installation unit - 1 - from vehicle with a second technician.

Installing





- With a second technician, insert installation unit - 1 - into roof cutout.

- During installation, align installation unit - 1 - via two cylindrical pins (reversed drill bit) 12 mm at right front - arrow - and 10 mm left rear - arrow - in roof.

Installation unit must not make contact with roof frame.

- Insert bolts - 2 -.

- Check wires and harness connectors for electrical consumers at roof for correct routing and reproduce if necessary.

- Firmly bolt (8 Nm) installation unit - 1 - of drive motor for sunroof - 5 - beginning at left and right toward rear.

- Install water drain hoses - 4 -.

- Connect harness connector - 3 - for drive motor of glass panel for sunroof - 5 -.

- Install molded headliner