Operation CHARM: Car repair manuals for everyone.

Front Seat Backrest Cover and Cushion






Front Seat Covers and Upholstery

Front Seat Backrest Cover and Cushion

Removal and installation of the components are described for the left seat. The same procedure applies for the removal and installation of the components of the right seat.

Removal

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove front seat. Refer to => [ Front Seat ] Front Seats

- Attach the seat to the fixture for seat repair (VAS 6136).

- Remove front right seat trim. Refer to => [ Right Seat Trim ] Front Seats

Vehicles with manual seat adjustment

- Remove front left seat trim. Refer to => [ Left Seat Trim ] Front Seats

Vehicles with electric seat adjustment

- Remove left power seat trim. Refer to => [ Left Power Seat Trim ] Front Seats

All vehicles

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Front Seats

- Attach the backrest to the fixture for seat repair (VAS 6136).

- Press corresponding button in headrest guide and pull headrest - 1 - out of backrest.

2-door only

- Remove operating knob - 2 -.

- Position a screwdriver in - direction of arrow - and pry trim - 3 - out of mount.

When installing, securing spring - 4 - must be removed from lever - 5 - and replaced.

Only vehicle (Rabbit from MY 2004) with manual lumbar support adjustment

- Remove the lumbar support adjusting wheel - 6 - using the Pliers (3392).

All vehicles

- Disengage backrest profile - 7 - on both sides.

- Release profile - 8 - from mount - 9 -.





- Loosen side profile - 1 - and - 2 - from mounts and fold back side of cover upward.

- Remove plate - 3 - from backrest.

- Open side profile - 4 - and disengage tension wire - 5 -.

- Open side profile - 7 - and disengage tension wire - 6 -.





- Fold cover - 5 - upward.

- Using a small screwdriver, unclip profiles - 1 - for cover out of mounts - 2 - in upholstery.

- Disengage tension wire - 4 - on both sides from upholstery wire - 3 -.

- Remove headrest guides. Refer to => [ Headrest Guides ] Front Seats

- Remove the cover - 5 - and upholstery - 6 - from the seat frame - 7 -.





Installation

- To install, perform the steps used for removal in reverse order.

2-door only

To prevent damage to the cover when folding the front seat backrests, ensure tensioning bands are positioned correctly.





1 - long tensioning band, tunnel side

2 - short tensioning band, tunnel side

3 - long tensioning band, sill side

4 - short tensioning band, sill side

The long tunnel side tensioning band should be guided between upholstery and seat structure side panel, then clipped into side panel from the inside - arrow -.





The short tunnel side tensioning band - 1 - should be guided between the upholstery and side panel and clipped under seat sideways into seat pan - arrow -.





The long sill side tensioning band - 1 - should be guided along the cover and engage in the front area of the panel bracket - 2 - - arrow -.





The short sill side tensioning band - 1 - should be guided between the upholstery and side panel and clipped under seat sideways into seat pan - arrow -.