Front Seat Pan Covers and Upholstery

Front Seat Covers and Upholstery

Front Seat Pan Covers and Upholstery

• Removal and installation of the components are described for the left seat. The same procedure applies for the removal and installation of the components of the right seat.


If the upholstery, front seat cushion on front passenger side is replaced, Front Passenger's Seat Occupied Sensor (G128) also must always be replaced.

Removal

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove front seat. Refer to => [ Front Seat ] Front Seats

- Attach the seat to the fixture for seat repair (VAS 6136).

- Remove the front seat belt latch:

• 2–door: => [ Belt Latch, 2-door ] Seat Belts

• 4–door:=> [ Belt Latch, 4-door ] Seat Belts

- Remove front right seat trim. Refer to => [ Right Seat Trim ] Front Seats

Vehicles with manual seat adjustment

- Remove front left seat trim. Refer to => [ Left Seat Trim ] Front Seats

- Remove bracket and front seat operating lever. Refer to => [ Front Seat Support And Operating Lever ] Front Seats

Vehicles with electric seat adjustment

- Remove left power seat trim. Refer to => [ Left Power Seat Trim ] Front Seats

- Remove retainer and power seat bracket. Refer to => [ Bracket and Support, Power Seat ] Front Seats

All vehicles

- Remove front seat drawer mount. Refer to => [ Seat Drawer Mount ] Front Seats

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Front Seats

- Remove profile - 1 - from receptacle.

- Disengage retaining straps - 2 - from seat on both sides.

- Disengage profiles - 3 - from mounts on both sides of seat.

- Disengage profile - 4 - from mount on front side of seat.

- Roll cover upward on outer sides around circumference.





- Using a small screwdriver, unclip profiles - 1 - for cover out of mounts - 2 - in upholstery.

- In vehicles with seat heater, disconnect wiring harness - 3 - from seat frame.

- Remove the cover - 4 - and upholstery - 5 - from the seat frame - 6 -.





Installation

- To install, perform the steps used for removal in reverse order.