Oil Filter Housing: Locations
Oil Filter Housing Assembly Overview
1 - Locking bolt, 15 Nm
^ If sealing ring is leaking cut open and replace.
2 - Oil pressure switch F1, 20 Nm
^ 0.9 bar switch
^ If sealing ring is leaking cut open and replace.
3 - Oil filter housing
^ With check valve
^ Opening pressure 0.05 bar pressure
4 - O-ring
^ Replace
^ Oil before assembling
5 - Oil cooler
^ Ensure sufficient clearance to surrounding components
6 - Seal
^ Replace
^ Oil before assembling
7 - Oil cooler cover, 25 Nm
8 - Oil cooler sealing ring
^ Replace
^ Oil before assembling
^ Insert into grooves on oil cooler
9 - 23 Nm
10 - Oil filter element
^ Observe change intervals
11 - Screw cap, 25 Nm
12 - Oil drain plug, 10 Nm
Oil Cooler Sealing Ring Installation Position
- Install oil-soaked gasket in the oil cooler as illustrated. Observe installation position.