Fuel Injector, Checking

Fuel Injector, Checking

The following test procedure is used to diagnose Fuel Injectors (N30, N31, N32, N33, N83, N84).

Special tools, testers and auxiliary items required

• Multimeter.

• Diode test lamp (12V).

• Wiring diagram.

Test requirements

• Fuse (SB6) OK.

• Battery voltage at least 12.5 volts.

• All electrical consumers such as, lights and rear window defroster, switched off.

• Vehicles with automatic transmission, shift selector lever into position " P" or "N".

• A/C switched off.

• Ground (GND) connections between engine/transmission/chassis OK.

• Ignition switched off.

- Observe Safety Precautions.

- Observe rules for cleanliness.

Test procedure

- Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] Preliminary Check.

Start diagnosis

- Disconnect the Fuel Injector electrical harness connectors from Fuel Injectors (N30, N31, N32, N33, N83, N84).

Checking internal resistance

- Using a multimeter, check the Fuel Injector electrical terminals 1 to 2 for resistance.





Specified value: 12.0 to 20.0 ohms (at approx. 20° C)

If the specified value was not obtained:

- Replace the faulty Fuel Injector.

If the specified value was obtained:

Checking activation and wiring

- Connect a diode test lamp (12V) to the electrical harness connector terminals 1 and 2 of the Fuel Injector to be tested.





- Operate the starter and test the activation of the Fuel Injector.

LED should flicker.

- Switch the ignition off.

If LED does not flicker:

If the specified value was not obtained:

If the manufacturers test box is being used. Perform the following step.

- Install the test box.

If the manufacturers test box is not being used. Perform the following step.

- Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Replacing ] Engine Control Module J623, Replacing.

- Using a Multimeter, check the Fuel Injector electrical harness connector terminals to the Engine Control Module (ECM) (J623) electrical harness connector T121 terminals for resistance.









Specified value: 1.5 ohms Max.

If the specification is not obtained:

- Check the wiring for an open circuit, a short circuit to each other, Battery (+), or Ground (GND).

- Check the electrical harness connector for damage, corrosion, loose or broken terminals.

- If necessary, repair the faulty wiring connection.

If no malfunction is found in the wiring:

- Erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] Diagnostic Mode 04 - Erase DTC Memory.

- Perform a road test to verify repair.

If the DTC does not return:

Repair complete, Generate readiness code. Refer to => [ Readiness Code Description ] Readiness Code Description.

- End diagnosis.

If the DTC returns and no malfunction is found in the wiring and the voltage supply was OK:

- Replace the Engine Control Module (ECM) (J623 ). Refer to => [ Engine Control Module J623, Replacing ] Engine Control Module J623, Replacing.

- Assembly is performed in the reverse of the removal.

Final procedures

After repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] Diagnostic Mode 03 - Read DTC Memory.

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] Diagnostic Mode 04 - Erase DTC Memory.

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] Readiness Code.

End of diagnosis