Drive Axle with CV Joint VL107 Attached
Drive Axle with CV Joint VL107 Attached
Special tools, testers and auxiliary items required
• Slide Hammer - Complete Set (VW 771)
• Puller (T10382)
Removing Outer Constant Velocity Joint
- Secure drive axle with protective covers in vise clamp.
- Fold back boot.
- Align the (T10382) so that the flat side of the plate (T10382/1) faces the spindles (T10382/2).
- Attach the puller to the (VW 771).
- Remove the CV joint from the drive axle using the (T10382 ) and (VW 771).
1. Plate (T10382/1)
2. Spindles (T10382/2)
Driving on Outer CV Joint
Installed Location of Spring Washer and Thrust Washer on Outer Joint
1 - Dished washer
2 - Thrust washer
- Install the new circlips.
- Slide new CV boot onto drive axle if necessary.
- Drive it onto shaft with plastic hammer until securing ring engages.
Removing the Inner CV Joint
- Secure drive axle with protective covers in vise clamp.
- Fold back boot.
- Align the (T10382) so that the flat side of the plate (T10382/1) faces the spindles (T10382/2).
- Attach the (T10382) to the (VW 771).
- Remove the CV joint from the drive axle using the (T10382 ) and (VW 771).
1. Plate (T10382/1)
2. Spindles (T10382/2)
Installing the inner CV joint
- Install the new circlips.
- Slide new CV boot onto drive axle if necessary.
- Drive it onto shaft with plastic hammer until securing ring engages.
Tightening Hose Clamp on Outer Joint
- Attach CV joint boot clamp tool (V.A.G 1682) as shown in illustration. Be sure that edges of clamping pliers are seated in corners - arrows B - of hose clamp.
- Tension clamp by turning spindle with a torque wrench (do not tilt clamp tool).
• A stainless steel clamp must be used due to hardness of CV boot material (compared to rubber). This clamp can only be tensioned using (V.A.G 1682).
• Tightening specification: 25 Nm.
• Use torque wrench - C - with adjustment range 5 to 50 Nm (for example torque wrench (V.A.G 1331)).
• Be sure thread of spindle - A - of clamp tool moves freely. Grease with MOS 2 grease if necessary.
• If it does not move freely, for example due to dirt in thread, the required clamp tension will not be achieved at the specified torque.
Tensioning Clamp on Small Diameter
