P0630

P0630 - VIN Not Programmed In PCM

For wiring diagrams, refer to.

• When Monitored: At initialization.

• Set Condition: The VIN has not been programmed into the PCM. One trip fault. Three good trips to turn off the MIL.






• Always perform the pre-diagnostic troubleshooting procedure before proceeding. Refer to => Non-DTC Based Diagnostics. Pre-Diagnostic Troubleshooting Procedure

Test Step 1 - VIN Not Programmed in the Powertrain Control Module

• Turn the ignition ON.

• Using the scan tool, program the VIN into the PCM.

• Start the engine and allow it to reach normal operating temperature.

• If the engine will not start, crank the engine for 15 seconds. Crank at least 2 times with the ignition switch returning to the off position each time.

• With a scan tool, select view DTCs.

Is the status active for this DTC?

Yes

• Replace and program the PCM.

• Perform the PCM Verification Test. Refer to => Non-DTC
Based Diagnostics. PCM Verification Test

No

• Test complete.

• Perform the PCM Verification Test. Refer to => Non-DTC
Based Diagnostics. PCM Verification Test