Front Overhead Console

Front Overhead Console

Special tools, testers and auxiliary items required

• Trim Removal Wedge (RMCP101)

Removing






- Disconnect the negative battery cable.

- Using trim removal wedge (RMCP101) , disengage the clips at the front edge of the overhead console (1).

- Once the front edge is released use your fingertips to grasp the sides of the overhead console (2) and pull straight down evenly to disengage the remaining two clips from the mounting bracket.






- Lower the overhead console far enough to access the wire harness connectors.

- Disconnect the courtesy lamps (2), light emitting diode lamp (3), infrared temperature sensor (4) and power sliding door/liftgate switch (1) electrical connectors, as equipped.

- Remove the overhead console from the vehicle.

Installing






- Position the front overhead console into the vehicle near the headliner.

- Connect the courtesy lamps (2), LED lamp (3), infrared temperature sensor (4) and power sliding door/liftgate switch (1) electrical connectors, as equipped.






- Grasp the sides of the overhead console (2) and push straight up evenly to engage the four snap clips into the bracket above the headliner (7).

- Connect the negative battery cable.