Rear Blend Door Actuator

Rear Blend Door Actuator

Removing

- Disconnect and isolate the negative battery cable.

- Remove rear HVAC housing (1) and place it on a workbench. Refer to => [ Rear HVAC Housing ] Rear HVAC Housing.






- Disconnect the wire harness connector (2) from the rear blend door actuator (3).

- Remove the two screws (4) that secure the rear blend door actuator to the back of the rear HVAC housing and remove the actuator.

Installing






- Position the rear blend door actuator (3) onto the rear HVAC housing (1). If necessary, rotate the actuator slightly to align the splines on the actuator output shaft with those on the rear blend-air door coupler.

- Install the two screws (4) that secure the rear blend door actuator to the rear HVAC housing. Tighten the screws to 1.2 Nm (10 in lbs).

- Connect the wire harness connector (2) to the rear blend door actuator.

- Install the rear HVAC housing. Refer to => [ Rear HVAC Housing ] Rear HVAC Housing.

- Connect the negative battery cable.

- Calibrate the HVAC control.