Display and Control Unit, Climatic

Display and Control Unit, Climatic

Removing

• The controls consist of two separable housings on the Passat from MY 06. Turn the controls to the following positions before removing them:

• Heater control to "cold"

• Blower to "0"

• Air flow direction to "footwell"

Removal on the Passat from MY 06, on the Passat CC from MY 09 and on the CC from MY 10 is identical.

- Remove the instrument panel center trim.

- Remove the screws (1.5 Nm) - 2 - (4.2 x 45 mm) and - 3 - (4.2 x 16 mm) and remove the heating and ventilation controls - 1 -.






- Release the connector - A - by pulling it in direction of arrow - 1 -.






- Press connector release - B - toward the connector - arrow 2 - and disconnect the connector - C -.

- Disconnect the connector - D -.

Installing

Installation is performed in reverse order of removal, make sure when doing so that the rotary buttons have the same position as when removing.