Engine Speed Sensor: Service and Repair

Engine Speed Sensor (G28)

Removing

- Remove the engine cover. Refer to => [ Engine Cover ] Engine Cover.

- Open the charge air pipe hose clamp - 2 -.






- Disconnect the electrical connector - arrow -.

- Remove the noise insulation.

- Remove the bolts - 1 and 4 - and remove the charge air pipe downward from the throttle valve control module (J338).

- Reposition the clamp - 1 - and remove the charge air pipe hose downward from the charge air cooler.






- Disconnect the electrical connector - 1 - from the engine speed sensor.






- Remove the engine speed sensor bolt.

Installing

Installation is carried out in the reverse order while noting the following:

• Tightening specifications, refer to => [ Ignition System Component Overview ] Service and Repair.